|
|
Thank you for your interest in publishing with us.
We publish your specialist book, conference proceeding, thesis etc.
Please consider the tips below.
If you intend to forward your manuscript on disk, have a look
here
.
Index
The printed area should be equally positioned on all pages (front and back).
The margin (top, bottom, left and right on the page) should be at least 2 cm.
The space between the page numbers and the text should be the same on every page.
In case you have a line at the top of each page, make sure that they are always congruent.
The font size should be chosen big enough, so that the text is still readable when
scaled down. The size in diagrams and pictures should not be smaller than 6 pt. (2 mm).
Illustrations have to be pasted into the text with assembly glue
(e.g. Marabu Fixogum) on all four edges.
To distinguish different areas in graphics, please hatch or rasterise them.
The density of dots should not be finer than 28 lpi.
Please avoid fine lines (less than 0.3 mm) in formulas and illustrations.
Page 1 in the manuscript is the title page of the author.
See exceptions for
specialist book
,
conference proceeding
and
thesis
.
Page 2 (back of page 1): blank page.
See exceptions for
specialist book
,
conference proceeding
and
thesis
.
Page 3: publisher's page and
Page 4:
copyright page is designed by the publisher.
Page 5 (if necessary also page 6) contains the preface and/or credits by the author.
From page 7 or from the table of contents as the case may be up to the beginning of the text,
the pages should be counted in Roman numerals.
In a book, all odd page numbers are to be found on the right.
Therefore, chapter beginnings should always be on the right side
(i.e. a page with an odd number). The main text has to be paged continuously in Arabic numerals.
If there are an appendix or figure pages after the text, they have to be paged as well.
Grey areas of different gradation should be provided with a grid pattern that is not finer than 28 lpi
(lines per inch). Please paste photos into your work with assembly glue. Photos are not easily
reproducible, they have to be rasterised. In case your work contains scanned illustrations,
please make sure that in they are rasterised coarsely enough the printout. It is also possible to hand in all
graphics separately as a postScript-file; we will insert them into your book then. Please bear in mind that
their size (in the postScript-file) has to be the same as it is supposed to be in the final format.
The final format of the book can be either A5, A4, B5, or every other format of your choice.
Therefore your actual format has to be adjusted, according to the general information on these pages.
The final format of the book can be either A5, A4, B5, or every other format of your choice.
Therefore your actual format has to be adjusted, according to the general information on these pages.
A decision on the conditions has to be made between author and publisher.
Paging: page 1 in conference proceedings should also contain information about location
and date of the conference.
Authors of theses profit from
essential advantages
when publishing professionally with us.
The final format of the book can be either A5, A4, B5, or every other format of your choice.
Therefore your actual format has to be adjusted, according to the general information on these pages.
A decision on the conditions has to be made between author and publisher.
Page 1, the title page of the author, contains information about the thesis.
Page 2 contains the name of the supervisor and possibly of the second examiner and
also the names of the members of the manuscript commission.
|
|